Oblyss Logo
Sign In
Get Started
Oblyss Logo
Get Free Trial
Sign in
INDUSTRIES · FOUNDATION REPAIR

Software For Crews Who Lift, Stabilize, And Underpin.

From the first inspection to the signed contract, the pier log, and the warranty, run every foundation repair job in one platform built for how these jobs actually get sold, installed, and documented.
See It On A Foundation Job
Who It's For

Job #2291 · Foundation Repair

In Production
14 Maple St · 12 push piers · Slab settlement
Estimate #2291 Signed
Pier log 7 of 12 logged
Pier 7 Flagged
WHO IT'S FOR

Built For Every Kind Of Foundation Work.

Whether you lift a single slab or stabilize a commercial building, the job runs on the same record: inspection, estimate, contract, work order, pier log, and warranty.

Foundation repair contractors
Residential foundation repair
Commercial foundation repair
Slab foundation repair
Basement foundation repair
Crawl space foundation repair
Pier and beam foundation repair
House leveling
Foundation settlement repair
Foundation crack repair
Foundation wall repair
Foundation stabilization
Underpinning contractors
Helical pier installation
Push pier installation
Concrete pier repair
Steel pier systems
Foundation lifting and stabilization
Foundation inspection companies
WHERE FOUNDATION JOBS BREAK DOWN

The Piers Are In The Ground. The Proof Is On A Clipboard.

A foundation job is sold on one visit, signed on another, and installed by a crew that was never in the room for either. Torque readings get scribbled on a pad, photos sit on personal phones, and the estimate doesn’t always match what went in the ground.

When a homeowner calls three years later about a warranty, the job record has to answer for itself.

THE SHORT VERSION

One record carries the inspection, the estimate, the signed contract, the crew’s work order, every pier’s torque, depth and elevation, and the warranty that follows.

WHAT GOES WRONG, AND WHAT FIXES IT

Six Problems Foundation Crews Know Well.

1

Pier readings kept on paper

Torque and depth get written on a pad and typed up later, if at all. Pier logs capture torque, depth, and elevation at the pier.

2

A pier under spec nobody caught

It stays a problem whether or not anyone noticed it on site. Readings are checked against published minimums and flagged.

3

Photos that were never taken

Proof gets requested after the crew has left the site. Required-photo steps won't mark complete without one attached.

4

Estimate and install drift apart

The crew works from a verbal brief, not what was sold. Work orders carry the written task list to the crew's phone.

5

Contracts that can be contested

A missing clause or notice only shows up when it is tested. E-signature proof and the Notice of Cancellation come standard.

6

Warranty answers lost in a file cabinet

Years later, nobody can find what was installed or when. Warranties are logged against the job and searchable.

THE PIER LOG

Every Pier, Logged Where It Goes In.

Whether the crew is driving push piers, installing helical piers, setting steel systems, or repairing concrete piers, the reading goes into the app at the pier, not onto a clipboard.

  • Torque, depth, and elevation logged pier by pier.
  • Checked against published minimums the moment it is entered.
  • A flagged pier is surfaced for review, not buried in a paper log.
  • Works with no signal and syncs when the crew is back online.
Pier Log · Job #2291
Minimums: 500 ft-lb torque · 8 ft depth
Synced
PIER
TORQUE
DEPTH
ELEV.
STATUS
5
560 ft-lb
10 ft
+0.3 in
OK
6
540 ft-lb
9 ft
+0.4 in
OK
7
420 ft-lb
9 ft
+0.2 in
Flagged
Pier 7: below minimum torque Photo required
A FOUNDATION JOB, START TO FINISH

One Record From Inspection To Warranty.

The job never leaves the platform, so nothing has to be re-keyed, re-checked or argued about later.

Step 1

Inspect

Findings captured and shared with the homeowner.

Inspection Reports
Step 2

Estimate

A branded estimate built and signed in minutes.

See Estimates
Step 3

Contract

E-signed with proof and the cancellation notice attached.

See Contracts
Step 4

Install

Work order and pier log run on the crew's phone.

See Work Orders
Step 5

Warranty

The warranty is logged against the job and searchable.

See Warranties
FOR EVERY FOUNDATION TYPE

Slab, Basement, Crawl Space, Pier And Beam.

Settlement, cracks, wall movement, and leveling each get sold and documented differently. Your estimates, work orders, and pier logs follow the repair you actually sell, not a generic template.

  • Residential and commercial jobs on the same platform.
  • Multiple crews and branches, each seeing only what they need.
  • Inspection companies can run reports and hand off to the repair crew.
WHAT OBLYSS HANDLES FOR FOUNDATION CREWS
Jobs and pipeline First call to final payment
Inspection reports Findings shared
Estimates and contracts Signed with proof
Work orders Required-photo steps
Technician app Opens in the phone's browser
Pier logs Torque, depth, elevation
Warranties Logged and searchable
QUESTIONS FOUNDATION CONTRACTORS ASK

Frequently Asked Questions

Does the pier log work for helical, push, concrete, and steel piers?
The pier log records torque, depth, and elevation pier by pier, so the same log works whichever pier system the crew installs.
It is flagged for review the moment the reading is entered, instead of sitting unnoticed in a paper log.
Yes. Logs and photos save on the phone and sync as soon as signal returns.

No. It runs in the phone’s browser. Open app.oblysspro.com, add it to the home screen, and it opens like an app. See the Technician App.

Yes. Inspection reports capture detailed findings and share them with the homeowner, with or without a repair job following.

Put The Whole Foundation Job On One Record.

Book a 30-minute demo and watch a job go from inspection to pier log to warranty.
Book a 30-minute demo
Start a free trial